Boxes.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

space below holes of FingerHoleEdge (multiples of thickness)

"spring", "stud" or "none"

horizontal width of the hook

horizontal space to the hook

height of the horizontal bar of the hook

height of the hook top to bottom

vertical spacing of slots middle to middle (in mm)

space below holes of FingerHoleEdge (multiples of thickness)

space surrounding connectors (multiples of thickness)

"stud" or "none"

horizontal width of the hook

space below holes of FingerHoleEdge (multiples of thickness)

angle of the cut (0 for horizontal)

"stud" to brace against the wall, "hook" for attaching to a second cleat or "none" for just straight

horizontal width of the hook in mm

distance of the cleats in mm (for bottom hook)

space below holes of FingerHoleEdge (multiples of thickness)

inside angle of the feet

height of strips to be glued to the inside of bottom edges (multiples of thickness)

height of the feet (multiples of thickness)

distance from finger holes to bottom edge (multiples of thickness)

width of the feet (multiples of thickness)

Type of wall system to attach to

treat sizes as outside measurements 🛈

inner width in mm

inner height in mm

inner depth in mm

fraction of bin height covered with slope

angle of the bottom slope

include a label area on the front

fraction of bin height covered with label (if label is enabled)

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈