Console et plateau incliné où placer du matériel
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
"ressort", "clou" or "rien"
horizontal width of the hook
horizontal space to the hook
height of the horizontal bar of the hook
height of the hook top to bottom
vertical spacing of slots middle to middle (in mm)
space surrounding connectors (multiples of thickness)
"stud" or "none"
angle of the cut (0 for horizontal)
"stud" to brace against the wall, "hook" for attaching to a second cleat or "none" for just straight
horizontal width of the hook in mm
distance of the cleats in mm (for bottom hook)
Thickness of the Skandis board
How to hook into the wall
Type of wall system to attach to
sections left to right in mm 🛈
hauteur interieure en mm (si on ne choisit pas « extérieur »)
treat sizes as outside measurements 🛈
profondeur en haut
profondeur en bas
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
Générer Download Save to URL QR Code
