Caixas.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

type of handle

type of lid to create

height of the handle in multiples of thickness (if applicable)

height of the brim in multiples of thickness (if any)

play when sliding the lid on in multiples of thickness (if applicable)

altura interna em mm (a menos que a opção de medida externa esteja selecionada)

altura interna das paredes internas em mm (a menos que a opção de medida externa esteja selecionada)(deixe como zero para usar a mesma altura das paredes externas)

treat sizes as outside measurements 🛈

sections left to right in mm 🛈

sections back to front in mm 🛈

• Set sx and sy before editing this!
• You can still change measurements afterwards
• You can replace the hyphens and vertical bars representing the walls with a space character to remove the walls.
• You can replace the space characters representing the floor by a "X" to remove the floor for this compartment.
• Resize text area if necessary.

thickness of the material (in mm) 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈

format of resulting file 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

style for inner corners 🛈

spacing around parts (multiples of thickness [: extra space in mm]) 🛈

print surrounding boxes for some structures 🛈