Boxes.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

type of handle

type of lid to create

height of the handle (if applicable)

height of the brim (if any)

play when sliding the lid on (if applicable)

hauteur interieure en mm (si on ne choisit pas « extérieur »)

hauteur des cloisons internes interieure en mm (si on ne choisit pas « extérieur ») (laisser à zéro pour des cloisons aussi hautes que les bords)

treat sizes as outside measurements 🛈

sections left to right in mm 🛈

sections back to front in mm 🛈

• Set sx and sy before editing this!
• You can still change measurements afterwards
• You can replace the hyphens and vertical bars representing the walls with a space character to remove the walls.
• You can replace the space characters representing the floor by a "X" to remove the floor for this compartment.
• Resize text area if necessary.

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈