Boxes.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

type of handle

type of lid to create

height of the handle (if applicable)

height of the brim (if any)

play when sliding the lid on (if applicable)

sections left to right in mm 🛈

Innere Tiefe in mm (außer wenn Außenmaß markiert ist)

Innere Höhe in mm (außer wenn Außenmaß markiert ist)

treat sizes as outside measurements 🛈

angle of the ramps

height of the ramps relative to to total height

have ramps on both sides. Enables sliding dividers

have a vertical wall at the ramp

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈