SevenSegmentClock

Seven segment clock build with LED stripe

Settings for Finger Joints

style

style of the fingers

surroundingspaces

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

edge_width

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

finger

width of the fingers (multiples of thickness)

play

extra space to allow finger move in and out (multiples of thickness)

space

space between fingers (multiples of thickness)

width

width of finger holes (multiples of thickness)

SevenSegmentClock Settings

height

height of the front panel (with walls if outside is selected) in mm

depth (with walls if outside is selected) in mm

outside

treat sizes as outside measurements 🛈

Default Settings

thickness

thickness of the material (in mm) 🛈

format

format of resulting file 🛈

tabs

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

qr_code

Add a QR Code with link or command line to the generated output

debug

print surrounding boxes for some structures 🛈

labels

label the parts (where available)

reference

print reference rectangle with given length (in mm)(zero to disable) 🛈

inner_corners

style for inner corners 🛈

burn

burn correction (in mm)(bigger values for tighter fit) 🛈

You need a LED stripe that is wound through all segments in an S pattern and then continuing to the next digit while the stripe being upright on its side. Selecting debug gives a better idea how things fit together.

Adding a diffuser on top or at the bottom of the segment holes will probably enhance the visuals. Just using paper may be enough.

There is currently not a lot of space for electronics and this generator is still untested. Good luck!

Boxes.py

SevenSegmentClock

Settings for Finger Joints

SevenSegmentClock Settings

Default Settings