Caixas.py

RoundedTrapezoidBox

Trapezoid box with rounded vertical edges.

Configurações para Encaixes Dentados

estilo

style of the fingers

espaços circundantes

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

Largura Borda

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

dedo

width of the fingers (multiples of thickness)

liberdade de movimento

extra space to allow finger move in and out (multiples of thickness)

espaço

space between fingers (multiples of thickness)

largura

width of finger holes (multiples of thickness)

Configurações para juntas rabo de andorinha

ângulo

quanto os encaixes devem alargar (-80 a 80)

profundidade

how far the dove tails stick out of/into the edge (multiples of thickness)

Raio

radius used on all four corners (multiples of thickness)

tamanho

from one middle of a dove tail to another (multiples of thickness)

Configurações para Flex

esticar

Hint of how much the flex part should be shortened

conexão

width of the gaps in the cuts (multiples of thickness)

distancia

width of the pattern perpendicular to the cuts (multiples of thickness)

largura

width of the pattern in direction of the cuts (multiples of thickness)

RoundedTrapezoidBox Settings

profundidade interna em mm (a menos que a opção de medida externa esteja selecionada)

altura interna em mm (a menos que a opção de medida externa esteja selecionada)

exterior

treat sizes as outside measurements 🛈

x_front

front width (assuming radius == zero) in mm

x_back

back width (assuming radius == zero) in mm

radius_front_left

radius of front left corner in mm

radius_front_right

radius of front right corner in mm

radius_back_right

radius of back_right corner in mm

radius_back_left

radius of back left corner in mm

wall_pieces

number of pieces for outer wall

topo

estilo da parte superior e da tampa

Configurações Padrão

espessura

thickness of the material (in mm) 🛈

gravar

burn correction (in mm)(bigger values for tighter fit) 🛈

formato

format of resulting file 🛈

labels

label the parts (where available)

referência

print reference rectangle with given length (in mm)(zero to disable) 🛈

tabulação

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

qr_code

Add a QR Code with link or command line to the generated output

inner_corners

style for inner corners 🛈

espaçamento

spacing around parts (multiples of thickness [: extra space in mm]) 🛈

debugar

print surrounding boxes for some structures 🛈

The x and y measurements are for a trapazoid with sharp corners. The radii cut the corners so the actual width is smaller for all trapazoids except rectangles.

Two boxes side by side