Boxes.py

RoundedTrapezoidBox

Trapezoid box with rounded vertical edges.

Einstellung für Fingerzinken

Stil

style of the fingers

umliegende Fläche

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

Kantenbreite

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

Zapfen

width of the fingers (multiples of thickness)

Bewegungsfreiraum

extra space to allow finger move in and out (multiples of thickness)

Abstand

space between fingers (multiples of thickness)

Breite

width of finger holes (multiples of thickness)

Einstellungen Schwalbenschanzverbindung

Winkel

wie weit sollten die Finger gespreizt werden (von -80 bis 80)

Tiefe

how far the dove tails stick out of/into the edge (multiples of thickness)

Radius

radius used on all four corners (multiples of thickness)

Größe

from one middle of a dove tail to another (multiples of thickness)

Einstellung für die Krümmung

Dehnung

Hint of how much the flex part should be shortened

Verbindung

width of the gaps in the cuts (multiples of thickness)

Entfernung

width of the pattern perpendicular to the cuts (multiples of thickness)

Breite

width of the pattern in direction of the cuts (multiples of thickness)

RoundedTrapezoidBox Settings

Innentiefe in mm

inner height in mm

x_front

front width (assuming radius == zero) in mm

x_back

back width (assuming radius == zero) in mm

radius_front_left

radius of front left corner in mm

radius_front_right

radius of front right corner in mm

radius_back_right

radius of back_right corner in mm

radius_back_left

radius of back left corner in mm

Oberseite

Art der Oberseite und des Deckels

Standardeinstellungen

Stärke

thickness of the material (in mm) 🛈

burn

burn correction (in mm)(bigger values for tighter fit) 🛈

Format

format of resulting file 🛈

labels

label the parts (where available)

Referenz

print reference rectangle with given length (in mm)(zero to disable) 🛈

Laschen

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

qr_code

Add a QR Code with link or command line to the generated output

inner_corners

style for inner corners 🛈

Mindesabstand

spacing around parts (multiples of thickness [: extra space in mm]) 🛈

debug

print surrounding boxes for some structures 🛈

The x and y measurements are for a trapazoid with sharp corners. The radii cut the corners so the actual width is smaller for all trapazoid except rectangles.