Boxes.py

RoundedTrapezoidBox

Trapezoid box with rounded vertical edges.

Settings for Finger Joints

style

style of the fingers

surroundingspaces

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

edge_width

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

finger

width of the fingers (multiples of thickness)

play

extra space to allow finger move in and out (multiples of thickness)

space

space between fingers (multiples of thickness)

width

width of finger holes (multiples of thickness)

Settings for Dove Tail Joints

angle

how much should fingers widen (-80 to 80)

depth

how far the dove tails stick out of/into the edge (multiples of thickness)

radius

radius used on all four corners (multiples of thickness)

size

from one middle of a dove tail to another (multiples of thickness)

Settings for Flex

stretch

Hint of how much the flex part should be shortened

connection

width of the gaps in the cuts (multiples of thickness)

distance

width of the pattern perpendicular to the cuts (multiples of thickness)

width

width of the pattern in direction of the cuts (multiples of thickness)

RoundedTrapezoidBox Settings

inner depth in mm

inner height in mm

x_front

front width (assuming radius == zero) in mm

x_back

back width (assuming radius == zero) in mm

radius_front_left

radius of front left corner in mm

radius_front_right

radius of front right corner in mm

radius_back_right

radius of back_right corner in mm

radius_back_left

radius of back left corner in mm

top

style of the top and lid

Default Settings

thickness

thickness of the material (in mm) 🛈

burn

burn correction (in mm)(bigger values for tighter fit) 🛈

format

format of resulting file 🛈

labels

label the parts (where available)

reference

print reference rectangle with given length (in mm)(zero to disable) 🛈

tabs

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

qr_code

Add a QR Code with link or command line to the generated output

inner_corners

style for inner corners 🛈

spacing

spacing around parts (multiples of thickness [: extra space in mm]) 🛈

debug

print surrounding boxes for some structures 🛈

The x and y measurements are for a trapazoid with sharp corners. The radii cut the corners so the actual width is smaller for all trapazoid except rectangles.