Boxes.py

凹槽应该加宽多少（-80到80）

how far the dove tails stick out of/into the edge (multiples of thickness)

radius used on all four corners (multiples of thickness)

from one middle of a dove tail to another (multiples of thickness)

卡榫样式

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

type of handle

type of lid to create

height of the handle (if applicable)

height of the brim (if any)

play when sliding the lid on (if applicable)

size of base in X direction (0=auto)

size of base in Y direction (0=auto)

number of grids in X direction (0=auto)

number of grids in Y direction (0=auto)

height of sidewalls of the tray (mm)

Extra margin around the gridfinity base to allow it to drop into the carrier (mm)

底边的边缘类型

edge type for sub panels

The Gridfinity pitch, in mm. Should always be 42.

The cutout for each grid opening. Typical is 38.

The corner radius for each grid opening. Typical is 1.6.

cut pads to be used for gridinity boxes from the grid openings

if pads are cut add holes for magnets. Typical is 6.5, zero to disable,

if magnet hole offset from pitch corners. Typical is 7.75.

The corner radius for each grid opening. Typical is 0.8,

the maximum sized panel that can be cut in x direction

the maximum sized panel that can be cut in y direction

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈