A parameterized Gridfinity base
how much should fingers widen (-80 to 80)
how far the dove tails stick out of/into the edge (multiples of thickness)
radius used on all four corners (multiples of thickness)
from one middle of a dove tail to another (multiples of thickness)
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
type of handle
type of lid to create
height of the handle (if applicable)
height of the brim (if any)
play when sliding the lid on (if applicable)
size of base in X direction (0=auto)
size of base in Y direction (0=auto)
number of grids in X direction (0=auto)
number of grids in Y direction (0=auto)
height of sidewalls of the tray (mm)
Extra margin around the gridfinity base to allow it to drop into the carrier (mm)
edge type for bottom edge
edge type for sub panels
The Gridfinity pitch, in mm. Should always be 42.
The cutout for each grid opening. Typical is 38.
The corner radius for each grid opening. Typical is 1.6.
cut pads to be used for gridinity boxes from the grid openings
if pads are cut add holes for magnets. Typical is 6.5, zero to disable,
if magnet hole offset from pitch corners. Typical is 7.75.
The corner radius for each grid opening. Typical is 0.8,
the maximum sized panel that can be cut in x direction
the maximum sized panel that can be cut in y direction
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
Generate Download Save to URL QR Code
This is a configurable gridfinity base. This design is based on Zach Freedman's Gridfinity system