Boxes.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

width of the visible part of the engraving in mm

height of the visible part of the engraving in mm

thickness of the engraving plate (and any acrylic window you may add) in mm

margin for the engraving plate insertion in mm

width of the frame in mm

radius of the frame outer corners in mm

radius of the frame inner corners in mm

Add a covenring front plate to glue (hiding the finger joints)

Add dummy finger holes and plugs for the unity of the frame (if not covered)

angle of the back support in degrees ; set 0 or negative value to ignore

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈