Boxes.py

angle intérieur des pieds

height of strips to be glued to the inside of bottom edges (multiples of thickness)

height of the feet (multiples of thickness)

distance from finger holes to bottom edge (multiples of thickness)

width of the feet (multiples of thickness)

sections left to right in mm 🛈

sections back to front in mm 🛈

hauteur interieure en mm (si on ne choisit pas « extérieur »)

treat sizes as outside measurements 🛈

type de bord pour le bord du bas

how to grab the lid to remove

radius of the grip hole in mm

width of hole(s) in percentage of maximum hole width

vertical margin for sliding lid (multiples of thickness)

margin to add at both sides of sliding lid (multiples of thickness)

create two strips to reduce waste material

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

Add a QR Code with link or command line to the generated output

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈