A showcase for a single coin
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
largura interna em mm (a menos que a opção de medida externa esteja selecionada)
profundidade interna em mm (a menos que a opção de medida externa esteja selecionada)
altura interna em mm (a menos que a opção de medida externa esteja selecionada)
treat sizes as outside measurements 🛈
The diameter of the coin in mm
The size of the coin plate
The height of the coin showcase piece
The angle that the coin will tilt as
thickness of the material (in mm) 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
format of resulting file 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
Add a QR Code with link or command line to the generated output
style for inner corners 🛈
spacing around parts (multiples of thickness [: extra space in mm]) 🛈
print surrounding boxes for some structures 🛈
Gerar Download Save to URL QR Code
