Shelf for holding (multiple) piles of playing cards / notes
内侧角度
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
the angle of arc cuts
the gap between grooves (fraction of the edge length)
alternate the direction of grooves
invert the groove directions
minimum space left and right without grooves (fraction of the edge length)
the style of grooves
the angle of triangular cuts
the width of each groove (fraction of the edge length)
卡榫样式
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
sections left to right in mm 🛈
内部深度（mm）（除非选择外部）
内部高度单位mm（除非选择外部）
treat sizes as outside measurements 🛈
backward angle of floor
make holders stackable
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
生成 Download Save to URL QR Code
